 |
RUBBER
LAGGINGS
Prevents light loads from slipping and protects
the surface of loads during transfer. Rubber
is molded (vulcanized) on to tube to assure
permanent adhesion. |
 |
BUILT-IN
BRAKE
Eliminate load inertia and enable precise
stopping. Electromagnetic brake is engaged
by spring force when power to the motor is
interrupted. Minimum tube length is 250mm
(10") and -One-touch- mechanism is included
with tube lengths of 300mm (12") or more.
Maximum Continuous energized time is 30 minutes
with a 70% duty cycle. |
 |
FREE
CLUTCH
* When power is on, Power Moller® functions
normally.
* When power is off, Power Moller® functions
as an idler roller.
* Available for PM570AS/PM605AS series models.
* The minimum tube length that Free Clutch
option can be
attached to is 11". In case the Power
Moller® has a
spring-loaded end cap, the said minimum length
is 13".
* Free Clutch option can be added to the Power
Moller® with
brake. In this case, the minimum tube lengths
are 13" without
a spring-loaded end cap and 15" with
a spring-loaded end cap. |
 |
WATERPROOF
Designed for outdoor lines or lines subject
to water spray (washdown).
Output and attaching shafts, end caps and
tubes are made of stainless steel to resist
corrosion. Waterproof specification IP-65,
IEC 529.
* Direct Water Spray to Shafts in Washdown
Application may reduce life
power of Moller.
* Waterproof Option may affect speed and torque.
* Contact Itoh Denki for speeds available. |
 |
DRIP
PROOF
Used on conveyor lines that are located in
areas with high moisture levels.
Attaching shaft and shaft caps are made of
stainless steel to resist corrosion. Drip
Proof specification IP-55, IEC 529. |
 |
DUST
PROOF
Used in dusty or powdery environments. Rubber
seals protect the POWER MOLLER® bearings
from contamination.
|
 |
CLEAN
ROOM
Designed for the handling line that requires
a high degree of cleanliness, such as in the
electronics, food and pharmaceuticals industries
etc. Includes the features incorporated in
the drip proof option as well as standard
leadwires and stainless steel tube, attaching
and output shafts. C2 - Class 100 Clean Room.
C3 - Class 1000 Clean Room. |
 |
BELT
PULLEY AND GROOVES
POWER MOLLER® and corresponding idler
rollers are available with a special end cap
or grooves to accommodate small V-belts
or round belts. The POWER MOLLER® can
be linked to idler rollers on light load/small
size applications where consecutive -live•
rollers are required. Minimum tube length
is 250mm (10") -One Touch• attaching
shaft is standard for all tube lengths. |
